removal tool for contacts in the multi-contact module
for seriesHan EEHan Q 5/0Han Q 8/0Han EHan ATC-20HAN PA removal tool is necessary if contacts are to be replaced in the insert.The tool is inserted from the wiring side until a stop is noticeable.The wire with the crimp contact can then be pulled out from the same side of the insert.
removal tool for crimp contactsHan C 1.5-6.0mm² (09 32...)A removal tool is necessary to remove the contacts.
removal tool for crimp contactsHan C 10.0mm² (09 32...)A removal tool is necessary to remove the contacts.\\n
removal tool for Han D contacts
removal tool for Han-Yellock module
Han-Modular Removal tool for single modules in plastic framese.g. Han-Eco, Han-Modular docking-framemetal
Han-Modular removal tool for modulesThermoplastic
removal tool for TC100 contacts
Removal tool for serie TC200 contacts
replacement-tip for removal tool 09990000012
SC contact for Gl fibre 50/125 µm or 62.5/125 µm ceramic ferrule
use for male and female contacts
SC contact for 1 mm POF
use as male and female contact
SC contact, male, for singlemode fibre 9/125 µm
SC-POF contact for 1 mm plastic fibre, crimp termination
Service removal tool for Han D contacts
20 + shielding, 5 A / 50 Vcontacts have to be ordered separate
Single HARTING guiding pins and bushes bit
crimp contact 10 mm²silver plated
crimp contact 6 mm²silver plated
crimp contact 0,14 - 0,37 mm²
crimp contact 0,14 - 0,37 mm²golden plated
crimp contact 0,5 mm²
E-mail address:
Password:
Warning, important!
This shop addresses commercial costumers only and therefore shows prices excluding tax. If you are an private costumer please activate Cookies and JavaScript in your browser.
You accept this by continuing shopping