PV-C4M-S6-16
Phoenix Sunclix Photovoltaic Cable Coupler Male 6,0-16,0mm² (-)

Photovoltaic Coupler
nominal current: 60
housing inclusive contact for wire gauge 6,0mm² - 16,0mm²
nominal voltage: 1500 V
Connection type: Sunclix spring

Phoenix article No.: 1284632

Connecting the cable (Fig. 1 )

• Strip the cable with a suitable tool by 15 mm.
  Make sure that no individual wires are cut off.
• Carefully insert the stripped wire with twisted litz wires all the way in.
  The litz wire ends have to be visible in the spring.
• Close the spring. Make sure that the spring is snapped in.
• Push the insert into the sleeve.
• Tighten the cable gland to 2 Nm.
• Bring the plug and the socket together.
  The connection snaps close thereby.
• Pull on the coupling to check the proper connection.

Separating the connector (Fig. 2)

• You need a slot screwdriver with a 3-mm wide blade
• Insert the screwdriver as shown in Fig.  2 .
• Leave screwdriver inserted and disconnect the plug and the socket from each other.

Loosen the cable (Fig 3)

• Screw open the cable gland.
• Insert the screwdriver as shown in Fig.  3.
• Pry the connection open and pull the sleeve and the insert apart.
• Open the spring with the screwdriver. Remove the cable.