Crimping Tools

for 1,5mm² + 2,5mm² + 4,0mm² + 6,0mm²
inkl. Die-set
inkl. Locator

for the following contacts:

• Tyco SolarLok
• HTS HA/HE
• HTS HN.D
• HTS HVT
• Harting HAN A/E
• Harting HAN D

- Self-adjusts to the desired ferrule size
- Ferrule insertion on the side of the tool
- 4 serrated crimping profiles
- Ferrule insertion on the side of the tool

For Crimping of Solar Couplers Male and Female MC 3
2,5mm², 4,0mm² and 6,0mm²
Die-Set included
inkl. Locator

For Crimping of Solar Couplers Male and Female MC 4
2,5mm², 4,0mm² and 6,0mm²
Die-Set included
Locator included

as addition or Spare Part

as addition or Spare Part
can be used for 2,5mm², 4,0mm² and 6,0mm²

optional supplement, use for PV-CZM-19100 + PV-CZM-20100

Spare Part for hand crimping tool PV-CZM-16100A
for 2.5, 4.0 and 6.0mm²

Multi-Contact article No. 32.6039

Spare Part, use for PV-CZM-19100 + PV-CZM-20100 for locator PV-LOC

Crimping tool with quick-change system

• Crimping tool for rapid exchange of different crimping dies
• external 5-piece magazine with practical belt clip for safe and clean storage of crimping dies
• Suitable for crimping insulated and non-insulated connectors and cable lugs or wire end ferrules
• easy tool-free exchange of Dies
• Dies are self-locking, no screws required - simply click into place - done
• low hand force through optimal leverage ratios
• Unlockable force lock for reliable, solder-free electrical crimp connections
• high operating comfort thanks to ergonomically designed two-component grips

Four-indent crimping tool with standard locator in plastic case

• use for crimping of turned male and female contacts (e.g.. HTS, Harting, Ilme...)
• Wire range 0,14 - 6,0 mm²
• Crimp dimensions adjustable in 0,01 mm increments
• Calibration by means of enclosed go - no go gauge
• Forced locking system and synchronous drive of indenters for high reliable crimp connections
• Manufacturer: Rennsteig Werkzeuge

Crimping Tool with Standard ident in plastic case (without locator)

• suitable for crimping turned pin and socket contacts (e.g. HTS, Harting, Ilme...)
• Conductor cross-section area 0,14 - 6,0 mm²
• Indents ajustable in 0,01 mm increments, digital reading
• Calibration by means of supplied go - no go gauge
• RESET function for recalibration
• Reliable crimping with force lock and synchronous crimp jaw movement
• Multifunctional digital display, with settings shown in mm, inches or MIL selector positions
• Mapping Locator position to Crimp spine position via the enclosed matrix

new Rennsteig article No.: 8753 0401 61